High performance punch press manufacturers to introduce the main parameters
of high performance punch.
1 of the nominal pressure exergy slider a distance before check in to the
next, the maximum force generated by the force of the slider, nominal pressure.
Nominal pressure punch mark, the unit is KN (KN) * (10KN=1 tons.) As our J23-40
is the 40 tons.
The 2 slide slider exergy BDC distance, generally unchanged. Exergy like
engine piston is always a reciprocating motion will not change, unless bad, such
as our J23-40 slider stroke is 90mm.
The number of 3 times a minute trip included the reciprocating motion of
the slider, our J23-40 stroke number is 55/min
4 check exergy by adjusting the length of the connecting rod screw, the
slider in the top and the position of the is as a slider adjustment quantity,
our j23-40 slider adjustment quantity is 50mm.
5 shut height exergy refers to the slider in the upper and lower dead point
position and slide block bottom surface to distance the countertop, check point
is the maximum closed height, next check point is the smallest closed height,
our j23-40 maximum closed height 240mm.
6 mold closing height refers to the mold closing down the upper and lower
end surface distance. Mould closing height should be located between the punch
closing height. 7 from our J23-40 aperture shank shank aperture size is shown in
42-70mm
High performance punch manufacturers professional production punch, the
quality is reliable, it is worth your purchase.
