Jinfeng punch manufacturer to remind you of a punch die installation should
pay attention to these points.
One Should first be confirmed before the installation of sharp edges of the
mold, no crack blade die, no missing angle. If there is a crack or flaw in the
press, please wear the edge.
Two Between the upper and the lower part of the clamp should be dead before
the pad a piece of silicon steel, to prevent the treatment process of blade
scratch.
Punch machine
Three Stroke adjustment to proper position compaction mode, we must ensure
that we die or die in the air at the bottom, gently close coordination of the
slide block, a pressing plate screw under pressure. Then, to adjust the slider,
remove the silicon steel sheet in the middle. Unscrew the screw template, adjust
the slide down, until 4 ~ 3 mm punching die, press the screw plate. New die
punch 3 ~ 4 mm must be in the concave die, otherwise, will be advantageous to
the perforation collapse or die.
Four Die punch before grinding, stone bottom and burr, clean up trash,
cleaning cloth. If there is a burr or garbage, the mold on the plane will lead
to the super poor lamination.
Jinfeng punch manufacturers of products with high quality and security, is
worthy of your trust, you are welcome to buy.